DS III centerboard installation dimensions

Regarding the DS3 only. Note that the DS3 is not a class-legal Day Sailer.

Moderator: GreenLake

DS III centerboard installation dimensions

Postby SMichelsen » Tue May 18, 2021 12:13 pm

I am in the process of installing a new centerboard for my 1986 O'Day Daysailer III. I bought the CB from Rudy at DS Marine. He has a template, provided to him from O'Day, that lays on top of the CB and shows the position of the holes for the CB pin and the downhaul line knot. Here are photos of the new CB, in it's crate, as shipped to me. Rudy drew the circle for the pin that the the CB will rotate on and the spot for the hole for the line. Also on top are the points for the three holes required to bolt down the stainless steel uphaul line bracket. I marked up the CB (actually drew on tape, not the CB!) to show distances and locations of the holes RELATIVE TO THE RECTANGULAR OUTSIDE DIMENSIONS, not the curved edges. Use this information at your own peril. Measure twice, cut once. I take no responsibility. OK, now that I said that here are the images. I will post photos of my CB after I rig it and before I install it.

Oday_Daysailer_III_cb_dims_3.jpg (148.88 KiB) Viewed 3438 times
Oday_Daysailer_III_cb_dims_2.jpg (146.52 KiB) Viewed 3438 times
Oday_Daysailer_III_cb_dims_1.jpg (124.71 KiB) Viewed 3438 times
Posts: 35
Joined: Sun Mar 18, 2018 1:29 pm

Re: DS III centerboard installation dimensions

Postby GreenLake » Tue May 18, 2021 3:23 pm

~ green ~ lake ~ ~
Posts: 7119
Joined: Mon Jun 18, 2007 3:54 am

Return to Day Sailer III Only

Who is online

Users browsing this forum: No registered users and 1 guest