Wood at coamings and stern

Topics primarily or specifically about the DS1. Many topics are of general interest, so please use forum sections on Rigging, Sails, etc. where appropriate.

Moderator: GreenLake

Wood at coamings and stern

Postby Relentless » Tue Mar 26, 2019 10:01 pm

When you install, do you normally use some kind of Marine caulking when you install?
Relentless
 
Posts: 14
Joined: Sat Dec 22, 2018 8:09 pm

Re: Wood at coamings and stern

Postby tomodda » Tue Mar 26, 2019 10:55 pm

I just have mine screwed down tight, no caulking. But mine are cut down for most of their lingth, for ease of sitting out on the decks. So I figure caulking isn't going to be holding out much water anyways.
tomodda
 
Posts: 132
Joined: Sun Aug 12, 2018 9:04 am

Re: Wood at coamings and stern

Postby GreenLake » Wed Mar 27, 2019 12:25 am

I used closed-cell foam tape with adhesive on one side. Stuck it to the deck and it squishes down and seals the gap between deck and coaming so if you bury your rail, or if spray runs along the deck from the front it does not trickle into the cockpit.

Found it at a boat store. Must be closed cell, so it can't become waterlogged. If you don't live near a good store, you can probably order online, e.g. fromhttps://www.fisheriessupply.com/. Something like this Marine WeatherSeal Tape.
~ green ~ lake ~ ~
GreenLake
 
Posts: 4822
Joined: Mon Jun 18, 2007 3:54 am

Re: Wood at coamings and stern

Postby kokko » Wed Mar 27, 2019 12:58 pm

I recall several used removable weatherstripping caulk
DS1 Truelove
kokko
 
Posts: 450
Joined: Tue Mar 11, 2008 4:17 pm
Location: St. Paul, MN

Re: Wood at coamings and stern

Postby GreenLake » Wed Mar 27, 2019 2:12 pm

You could use Butyl tape (available also at RV stores) but that may be overkill.
~ green ~ lake ~ ~
GreenLake
 
Posts: 4822
Joined: Mon Jun 18, 2007 3:54 am


Return to Day Sailer I Only

Who is online

Users browsing this forum: No registered users and 0 guests

cron